josephbennett Posted April 28, 2016 Share Posted April 28, 2016 I'm using the 4 cable method with my Pod HD500X with a DT50 112 amp. Without any metering as a guide, how do you go about setting the proper levels between the FX loops in both the Pod and DT? Quote Link to comment Share on other sites More sharing options...
J_V_RO Posted May 13, 2016 Share Posted May 13, 2016 Hope this helps: - POD "MASTER" knob at 100% (The channel volume on the POD can be adjusted as you wish) - AMP GAIN knob around 30%-40% - FX LOOP level at 100% (both AMP & POD) I never use the volume from my AMP at 100% because it affects my tone too much. (I have a Marshall MG100DFX), I'm always 40% - 60% of the volume. If you set the volume of your amp higher then I suggest to adjust the drive or gain of the effect that you are using to avoid unwanted sound. That's my experience. Good luck. Quote Link to comment Share on other sites More sharing options...
josephbennett Posted June 3, 2016 Author Share Posted June 3, 2016 Thank you I'll try your approach and let you know how I make out Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.