thewebgear

I figure how to get the M13 to send the signal to the Voodoo Control Switcher attached to my Mesa dual rec. There are no posts that I found the show how to do this with out a midi onboard amp. I talked to the line 6 support line and got great insight to make my set up awesome. There is a slight delay because the amp switches faster than the effect. You can control this with the timing of your switching so you don't get the raw amp burst before the effects can kick over. Overall I am extremely happy with the set up! Set the M13 midi setting on Omni in scene set up mode (it is a global effect) Change the Voodoo Switcher to accept CC and PC midi (unplug power...hold #2 button,,,..plug in power....light flashes) (Press button #1 and #2.....unplug and the settings are saved) Plug the Voodoo Switcher back in and your ready for set up Click on your scene and select the channels on the Voodoo Switcher Hold #1 and #4 at the same time to save settings to the scene. Now you have a non midi amp that you can switch channels and boost with your M13. No more tap dancing......

I reset it and it was fixed.

I have almost all my scene set up the same with few exceptions. I place the first two effects in pre and the last two in post. I just noticed yesterday that the two post effects are lighting up but not working. The effects work on other scenes but not on my main ones anymore. Yes, I checked the mix and levels and scene settings. I am thinking I might need to reset it but......what could cause that? Thank you,

It might be the same problem as the Behringer FCB1010. Check out this response to see if it would help you. http://line6.com/supportarchivenew/thread/49289

All my petals are spring loaded to go back to 0 when I pull my foot off them. Can anyone tell me the best way to do this by modding the ES-1 pedal? How would you do it?

I am looking for advice to set up a rig. I have the following pieces of equipment and would like ideas to make it work. Mesa dual rec Voodoo Labs Line 6 M13 (4 cable system) w/external pedal Morley Wah Pitch black tuner What I am looking for is midi control over the Mesa channels with the M13. Do I need to get a midi interface between the voodoo Labs switcher or a Line 6 control board to change scenes and amp channels? Can I set the Voodoo Labs switch to pick up the scene changes from the M13? I have research this all weekend and even seen posts with people that can do this with amps that have midi onboard. What should I get to make this all work? Thank you,