nickrobinson

On 7/11/2018 at 3:23 AM, sudiptasingh said:

Pressing and holding to clear the loop plays the 1st second of audio. Is there a CC message that we can assign to another switch to clear the loop in memory? 

I've requested this, no joy so far. It's infuriating live, so I've added an external mute switch to engage whist deleting - the HX doesn't have enough blocks for me to add this as an internal switch. Any easy fix to use midi, long overdue!

On 9/25/2018 at 6:18 PM, rocketop777 said:

- make sure 1st knob (parameter) is set to "Ch Vol"
- change 2nd knob (controller) to the open footswitch slot
- "Type" knob should be "latching"
- "Min Value" should be set to your base level (8.2 in this example)

- "Max Value" set it to something high enough to qualify as your "boost" - lets say "9.4"

 

fantastic tip - works for me & saves sending CC message to control my Katana volume ;)

I've written a page about the looping functions

http://looping.me.uk/hx-effects-looper-features/

On 9/11/2018 at 3:14 PM, phil_m said:

 

 The workaround is two hold down the footswitch on the second tap when stopping the loop playback (assuming you know you're done with that loop).

Fantastic, you've saved me some stress that way, although it *is* annoying if you're emptying the loop between songs and people hear that burst (guess I could mute whilst doing that, )    I'd still like to see a dedicated "stop" on the 6 sw - have it as an alternate option for the "play once" button, since I can't think of many who use that? I like to snag a loop during a verse, then stop it immediately for alter use and the double tap requires serious concentration to end the loop in perfect time then stop it almost immediately afterwards, but I guess I'll pick up the skill. 

my m9 looper is fed through the FX regardless of the setting of pre/post - any ideas?

Doh  - you have to be in looper mode then just toggle switch 3B. Can't think how I missed this. Thanks for your help!

> place the looper at the beginning of your signal chain

That sounds right, but I cannot find how to do this, after searching high & low on google ;(

Is it possible to route the looper through the effects so that when the looper is switched off, the reverb (for example) would apply to the loop?

I'd love to know if there will be further firmware updates, things like amp modelling, routing the loop to a different jack etc. It's a superb product but I'd hate to think it's at the end of it's development cycle ;(