gregd2790

The volume pedal is not working on the FBV3 and I have read up on how to fix it. There is a circuit board to replace. I talked to a Line6 rep who said order it through Full Compass and that Line6 had them in stock all Full Compass had to do is order it.. It's been two months.... Full Compass says it's still out of stock. Latest from Full Compass is that Line6 would supply it in September Is there any way I can get this from Line6 directly, or somebody else?

Did anyone ever figure out how to adjust the brightness on the FBV 3? I am having the same issue...just bought it a little while ago... was fine for a while... had it at a buddy's house indoors and it seemed to have lost its brightness... playing outside, forget it, I have to put my eyes right on it to see anything.

So I figured it out!! I have a Schecter guitar and it has built in sustainer that has 2 9 volt batteries... so it appears that even when the sustainer circuitry is not being used when the batteries go dead it affects the circuitry of the guitar. New batteries and great sounding amp again!

Had nice clean sounding amp, then all of a sudden every patch has this distortion sound almost like a blown speaker, except that I hear it in the headphones too. all patches, even a completely clean channel (no stomp pedals or anything.) I don't run the amp past 1/3 power. Practiced with the band for several hours, no problems. I am practicing at home a week later and here is this crunchy noise. I tried updating firmware, got the latest version but that didn't help. If it wasn't in the headphones I'd think it was speaker related but it sounds just as crappy in the headphones. HELP! I have gigs coming up !!