Hi all,
Just seeking clarification on a few things related to hd400 and flash update to 2.01
1. First of all, am I correct to assume that I should switch the output to Studio when connecting with 1/4" Out to a mixer (Tapco Mix100) which then goes to M1Active monitors. Between the two jacks coming out of the pod (R and L) there's a switch between Amp and Line. Which one should I select for that setup?
2. I've upgraded the firmware using the Monkey program and I've noticed that the volume of all/most factory patches are NOTICEABLY lower. I can barely hear some of them. While performing the upgrade there was a message that some of the tones may get changed but most of the patches are hardly audible. Any advice?
3. Any good resources for creating metal sounds (eg. Dream Theater)
It's my first amp modeller so please bear with me (I'm reading the manual).
Thank you