AaronKerr1979

Does anyone have any idea where exactly this gross low end is in the Xtra Red amp? Ive tried everything and I just cannot find it. I have tried surgically removing with the parametric eq, Ive tried a much broader approach with the shelf and tilt eq's. Ive tried pulling the amp's low back. Ive tried the bias and sag. It almost sounds like a light fuzz but just on the lows/low mids. Dropping 350 seems to help the best but it still isnt gone. It doesn't matter the IR/cab {yes i have tried low cut too] its always there. I LOVE the versatility of this model but this is driving me insane! HELP!

I have updated, the whole process went smoothly. Ive tried 5 or 6 times holding down C and D while powering on, and it just boots up as normal. Any ideas? I was a beta tester for this update

I know, I know, I COULD do this with snapshots easily. But I'm hardheaded, and very used to pedalboard mode. What I'd like to do is be able to switch between all three SHAPES of Cali Texas Channel 2 with one FS. Is this possible using command center in some way? I am aware of how to set it to switch between two modes, but how would I get it to cycle through all three? Again, I don't want to do snapshots (grumble at me all you want lol). Thanks for your time!

I bought a Tech 21 sansamp RK5 just before the pod released, I use it in the loop just for the reverb and delay. I dont need different proverbs or delays for different patches, so that works well for me. Also, I've found 2 different two-fer-ones. The legacy boost comp can be a comp and drive, and the dual delay could be set in mono for one pseudo-reverb and the other side for delay