madmel14

Monkey says my ESN is unknown. I upgraded the flash by file and I do not see any new upgrades or tones listed in the documentation and i am still getting the same message about tones/effects missing.

I have tried two different USB cables and am beginning to wonder if it may be the port. With that being said is there any way to get the two models, Power Pack and FX Junkie, back using the Midisport Uno. Losing those two model packs that came from the factory with the XT Live are the ones I used the most. I do not mind that I lost some custom tones because it will be kinda fun going back through the creation process. I just do not have access to all the effects and amps that I had before my XT Live did the "electronic belch" that lost everything but the standard model pack. Thanks

I checked and when I connect my XT Live to my computer using the Midisport Uno connector and run Monkey it says firmware is 1.12. I have connected to my two older computers and my daughter's new Macbook Pro with the Midisport Uno and it will recognize the XT Live but none of the computers will recognize the XT Live using the regular USB port on the XT Live. I have connected to every USB port on all three computers and I get nothing. On the Windows XP Pro computers I get the error message " device installed but will not start Error 10". Any suggestions, tips, help would be greatly appreciated. If there is anyone in central North Carolina that might want to give it a shot let me know. Thanks in advance!

I think it is 1.12

Monkey shows the current flash memory with the green check but it will not recognize the USB port on my XT Live. I am beginning to wonder if I could even download a purchase to the XT Live. If I am hooked up through the midi connectors Monkey will connect but it still will not let me update the drivers.

Hey Guys, I bought a Midisport Uno and used it tp connect my XT Live to my PC. Monkey recognized the connection and let me update the Flash Memory but it still will not let me update the Drivers. When I go through the Driver install and get to the part about connecting the USB to the computer the computer does not recognize the XTLive as new hardware so I force install it as per instructions and it loads the drivers but says the computer cannot start the device error 10. Is this a problem due to my computer not having 2.0 USB ports? Any other suggestions? Thanks in advance!

I have never purchased any model packs. The XT Live is just as it came from the factory. I did download Monkey but I cannot get my computer to recognize it through the USB port. My notebook pc has five different ports and I have plugged into all five and tried two different USB cables and I get no connection. Is there an alternate method, other than midi to connect or upgrade? Thanks

I have a POD XT LIVE I bought new in 2006. I have never had any issues with it until last week. I plugged in, turned on and played for a few minutes. I got a little fuzzy feedback sound and lost part of the pre-set tone I was using. The tone is still there it just does not sound the same. As I was going through the pre-sets I noticed when got to certain ones I would get the message "this tone contains an amp or effect from an expansion pack you do not own". I downloaded monkey to see if there were any updates and it says there are some but I cannot get monkey to recognize the POD XT LIVE with the USB cable. Is there another way to get my presets back or get my pc to recognize the USB. I am running windows xp pro. Thanks in advance!