DecanBlu

I updated Line 6 Updater, Helix Driver2 and WINUSB drivers like marcgilson suggested but no luck. Still dead in the water. Anyone else have any ideas.

Thanks markgilson! I will give that a try.

i was updating to release 3.50. when i came back to after a few minutes I have a message on the Helix LT of "Boot Failure. Entered Update Mode!" and it will not show any other screen. I have rebooted several times and as it starts up it shows that I am on version 3.50 but then immediately goes to the Boot Failure error and will not do anything else. HX Edit does not even show that I am connected to a device. Any ideas? I am dead in the water right now. Thanks in advance. Jim Newman

Thank you rd2rk. I will definitely give this a try. This has been a frustrating day. cool name!

Thank You Zappazapper. I will see how that goes when i get home. I just told my wife that I feel like I am missing something very simple and that would fit the bill. Thanks again.

I have the Helix LT and I want to use it with my Marshall DSL20HR using the 4 cable method. I want to be able to use the preamps in the Helix and basically use the Marshall head as a poweramp. I have it setup and it works BUT my question is, when I bypass the fx loop that goes to the front of the head and activate a preamp in the Helix I have no way of controlling the volume. I have bypassed the preamp of the head and now the volume knobs on the head are useless. There has to be a way to do this. Any ideas, thoughts or corrections to what I have done wrong are greatly appreciated. DecanBlu I set this up using several different methods basically following along step for step with some YT Helix presenters, Jason Sadites and am now using the method described by Richie Castellano. Signal path = Guitar > Helix Coming out of the SEND 1 on the Helix to the INPUT on front of Marshall head. (FX Loop 1 is set to INSTRUMENT level) - Coming out of the Effects SEND on the back of the head and coming into RETURN 1 on the Helix - Coming out of the 1/4" output on the Helix and going to the Effects RETURN on the head. I have a Send/Return Block in the preset. When it is on I get the Marshall and all of the effects perfectly. When I turn the Send/Return block off and turn on a preamp from within the Helix it and the effects work perfectly EXCEPT I have no way to adjust the volume coming out of the speaker cabinet except with the out volume on the preset or the volumes in the preamp module. This just will not work in a live or practical purpose.