jfever

Hi, S For some reason I am unable to toggle the looper "on". It is the only option I cannot adjust. It corresponds to fs4 I believe. Thanks.

it worked! thanks so much. I had some funkyness with some phasing it seems while blending both signals but I somehow worked that out. Thanks again this place is great.

found it. Trying it now.

Ok sorry but I have searched online and in the manual and cannot find how to configure inputs at a preset level. I will continue to look...

It seems a lot can be accomplished I preset level. I just need to dive in.

Thanks silverhead. I assume this setting will not negatively affect the guitar presets? Is this a global or a preset level change? (Input 1 = mic and input 2 = aux) checking that link now.

Silverhead sorry I did not specify earlier. I absolutely need both the 1/4" and the xlr mic level at the same time. This is a requirement. It's the way the pedal works to balance the sound. Part of the reason I'm not using pod presets for bass. Thanks again for all the help.

Silverhead sorry I did not specify earlier. I absolutely need both the 1/4" and the xlr mic level at the same time. This is a requirement. It's the way the pedal works to balance the sound. Part of the reason I'm not using pod presets for bass. Thanks again for all the help.

Yes! This is what I want. Only problem is that I still don't know how to do preset level routing. I only know the global input settings (hit "view" twice) that affect all presets which Brings up another point that I'm confused as hell with the fact that there is an input 1 and Input 2 (where is input2??) . I have more to learn.

The xlr connection is requiring a mic level input that is why I thought I could plug the xlr into the mic input on the hd500x. The reason is I would like to conserve my mixing board footprint. If I need to through the mixing board I'll bring my smaller mixer to daisy chain but then my question changes to "would I need to use both left and right xlr out and the the 1/4" stereo out (again left and right) from my mixer to the main mixer board (2 channels). Does this make any sense?

Yes hd500x. Thank you. I have no idea if my pedal can put out line level. Converting an xlr and a 1/4 into a single 1/8" jack sounds like a challenge. The bass preamp pedal is a sans amp svt.

I am using mic and aux inputs

Thanks so much for all the help. I did not think to look in the bass preset. Would that stuff be configured on the first node of the chain? I'll look at it and report back

Yes I hear it in the headphones separated left and right. If I monitor outside of the pod say from a mixing board and unplug the 1/4 I don't hear anything. If I am monitoring on the pod I lose one side of the headphones.

Hi, I am happy with my POD for guitar but want to route my bass through it as well. Basically I want to be able to switch between instruments (guitar and bass). I have some requirements, my bass chain is actually pedal based not using POD, it has 2 outputs I want to put into the POD and route the output through the POD output (which also is the output of the guitar). These will not be played at the same time. So I plug in the xlr and the 1/4" from the bass preamp pedal into the mix and 1/4aux input of the POD. I setup a basic preset without amp and can hear it fine through the headphones. When I plug into the mixing board (from the POD output XLR Left channel), I don't hear both xlr and 1/4 of the bass. Can anyone help? or is this a not recommended setup. thanks.