Hi guys, I hope some can help me with this.
I recently purchased an RJM Swith Gizmo so I could change my amp's channels using my POD HD500x. (My amp's a Laney LC30, 2 channels). I can't get the device to work properly, as I can only get it to switch from the dirty channel to the clean one, but not the other way around. (I'm using the POD with the 4CM. I read somewhere about FS mode?)
I followed the steps on your video, and the manufacturer's tutorials, without results. Then I tried MIDI assigning (I'm not tech savvy at all). On the POD, I assigned FS3 to the clean channel of my amp (midi ch: 02; message: program change; prog #: 001). If the dirty channel's on, I step on it and it goes to the clean channel, so far so good. But, then I assigned FS7 to the dirty channel, but it doesn't do anything (midi ch: 01; message: program change; prog #: 001) to turn on the dirty channel, and it doesn't work. I'd greatly appreciate any advice
