Hi,
So this might be a bit long winded but i want to make sure i explain evertyhing as best i can. So im using the HXFX to channel switch, as well as control external drive pedals in front of my amp, via midi controller (morningstar ML5). I'd also like to run time based effects in the effects loop of my amp, but can not seem to figure out how to set this up in the unit itself.
If i run from send 1 to send on my amp, and return from amp to return 1, I get very little sound. Yes, i have checked the settings for line/inst levels...and theyre good.
if i run a cable from send 1 to send on my amp, i have volume, but my channel switching volume is cut, in that you can barely tell what channel is on, still loud, just no difference really.
I've read the manual, it wasn't helpful and i could not find any videos of the setup that were not 4cm, which is not what im after. I know that i can do this, because ive seen it used on other boards, i just really dont know how the routing should be inside the HXFX.
see pics below for how my board is set and also the HXedit of how i understand the routing should be.
I would appreciate any information at all.
