eddievang

Unfortunately another user who’s reaper daw is not able to load audio device, Asio configuration button does nothing and input output fields are blank(Helix LT or Podgo) Both were working fine with reaper until large windows update a few weeks back. Both are still able to work with HX edit and pod go edit and the usb cables all work fine, audio will pass through helix and route to speakers including YouTube etc gone through everything others have tried on here, managed to bring core isolation up after going through bios and memory integrity switch then showed. Then I was able to see the line 6 drivers causing the issues, had to remove all files and reboot. after reboot memory integrity scan stated it would not engage due to corrupted drivers but the scan showed no drivers. obviously like many others spending far too much time on this and going down too many rabbit holes. Ive tried the driver for the memory integrity issue but obviously it needs the switch on! Any Ideas, I wouldn’t have thought it would be the line 6 hardware as both stopped working with reaper after the windows update. Thanks in advance E system HP laptop 8 gig ram over 1T storage and never had any performance issues

Unfortunately another user who’s reaper daw is not able to load audio device, Asio configuration button does nothing and input output fields are blank(Helix LT or Podgo) Both were working fine with reaper until large windows update a few weeks back. Both are still able to work with HX edit and pod go edit and the usb cables all work fine, audio will pass through helix and route to speakers including YouTube etc gone through everything others have tried on here, managed to bring core isolation up after going through bios and memory integrity switch then showed. Then I was able to see the line 6 drivers causing the issues, had to remove all files and reboot. after reboot memory integrity scan stated it would not engage due to corrupted drivers but the scan showed no drivers. obviously like many others spending far too much time on this and going down too many rabbit holes. Ive tried the driver for the memory integrity issue but obviously it needs the switch on! Any Ideas, I wouldn’t have thought it would be the line 6 hardware as both stopped working with reaper after the windows update. Thanks in advance E system HP laptop 8 gig ram over 1T storage and never had any performance issues

Thanks for your response Phil M User error. Turns out it was the DSP on the FRFR speakers that had gone to pole position rather than monitor, which is what it is always set on, just bizarre that it did this when trying the new vFirmware., anyway all good thanks. Duned in Dragon I only need a simple set up, not 300 presets and only asked a simple question, I have the sound I need with only 2/3 amps, and it is such a good sound! Fact, I did not ask for any empathy, so none was required, seems you didn’t read my question properly. See I only need so many sounds and if there good, which on this Helix LT there fantastic then that’s what I gig with, I don’t need to spend time doing 300 presets! So simple answer would have been, “never had that problem” or Like Phil M, “you shouldn’t have that problem“ Even better, have you checked your other gear, doh! Point here is, be helpful or don’t bother, no big boy pants required.

Hi All I have downloaded latest firmware version, and after following the instruction everything has gone like a dream. I updated from 2.54.0 Now when playing my presets, it now seems that (certainly on Archetype lead) there is an increase in Bass, bottom end that is very noticeable and takes away the clarity of that preset when I look at the latest factory preset for this amp the mid, treble, and presence are much higher than the old version, this does sound closer to my old firmware, but will mean adjusting all patches. Has any body else experienced similar? May have to consider going back to old firmware as this was my main sound. Thanks in advance for any help.