RTATKINSON
-
Posts
5 -
Joined
-
Last visited
RTATKINSON's Achievements
-
Excellent....thanks a million. That possibility just came to me when I was going ask what's wrong, but I wanted to see if anyone else had the same experience. I'll change them to be all the same and see if that works. Thanks again...cheers.
-
Excellent....thanks a million. That possibility just came to me when I was going ask what's wrong, but I wanted to see if anyone else had the same experience. I'll change them to be all the same and see if that works. Thanks again...cheers.
-
Hello all, first post here... I've been doing searches everywhere, including on here on how to keep a recorded loop going when you change to a different preset. I'm using the Helix LT with the 1 Switch Looper.....and have placed a looper an every preset I want to use for looping. It did work at one point, but for some reason, it shuts off now when I go to presets that once worked, and I don't know why. As I type this, I realize that I changed some of the 1 Switch Loopers from Mono to Stereo. Are these considered different loopers with will not recognize the fact that a looper is there when you change to a new preset? I'm going to check that out just in case, but if anyone has any "secrets" to share that must be in place for loops to continue when you change a preset, that would be great.....thanks.
-
Hello all, new to the forum and a new owner of the Helix LT. Updated to 2.8 following all instructions....all went smoothly, however after a week I noticed that one of the setlists (and only 1 of them), gives this error when I try to select it on the HX Edit software. (on the actual board it just keeps the setlist that I had populated prior to selecting the new one, no error message or anything) This is what I get on the HX Edit software..... Can't seem to find anything related to this on the Internet.....and as I mentioned, all other Preset Setlists work fine.....do I need to do something to clear this so that I can access the list? Any help would be appreciated......P.S. all worked fine prior to 2.8 firmware upgrade.....but not sure this is the problem.....