toko42

Including CC32 with the respective setlist somewhere in the MC6 Pro command works.

I want to switch setlists using a Morningstar MC6 Pro. So I created a "On Enter Bank" command and set CC32 to the value indicating the bank (0-7) which led to nothing. So I created another message "On Enter Bank" with a PC for the first preset I have in that bank which led to nothing, again. How can I do this? It would even be nicer being able to include CC32 in each MC6 preset but I am not aware how to do this. Thank you very much.

This works in priniciple but whenever you have to have a bassamp as monitor for the rest of the band, the IEM signal would also be feed to that amp.

I'd like to create a simple setup to be able to use my Helix with my bass and IEM in a way that - Bass is send to FOH via XLR - IEM uses Return1/2 with phones connected either directly to Helix or via wireless Right now this would work only with workarounds. - Send1 sends bass to FOH - Return 1/2 receives IEM without bass (!) to avoid phase cancellations This solution obviously works even with a Stomp but ignores the possibilities the larger devices offer. I would suggest to include 1/4" and XLR to Send outs to facilitate this in a future firmware.

That was obviously too straightforward for me but works fine. Thank you very much!

Is there a way to use both EXP1 and midi CC4 to control the main out volume? I found that I could program various parameters to be controlled by one of the footswitches as well as midi CC but not main volume.

Hi there. I've searched for this and found a topic where I found out that this was not possible with the VST2/3 versions in December 2020. If it's still not possible, are there plans to implement this? Thank you very much. Regards toko42

I have still set FS3 to work as "tuner enable" and added an external footswitch as FS4/5 as well as programmed some things to be switched via Midi. But somehow FS3 does not work to enable the tuner anymore. What did I do wrong?

No, I want to use one mixer channel for a clean signal and another one for the wet one. There are usually enough inputs available on my Behringer X32 and thus I could record a dry signal while still sending a wet one to the PA and alter the effects later if they don't sound good. But maybe this may work, too.

I usually use two paths to separate amp and anything else to keep a good low end. On a Stomp that's it... But thanks for the suggestion, I'll see what I can do.

Hi there, it would be nice to be able to have the wet signal on one output and the dry signal on the other. As both are balanced one could leave the DI at home. Right now I would have to include an FX send to be able to do this which uses one block. Would this be possible? Many thanks toko42

I'm probably not the only bassist who likes the Yamaha NE1 (or for that matter the reengineered Schalltechnik 04 clone) and would like to emulate it on the Helix Stomp. http://www.yamaha.com/yamahavgn/Documents/Guitars/ne1_1.pdf I tried to use the Parametric EQ but the Gain can only be lowered to -12 dB instead of the needed -20 dB for the Deep setting. Any hints on how I can solve this without using 2 EQs for which I will have to set not only the gain but the frequency setting separately? Probably this would also be a good candidate for a feature request with a low footprint :-) Many thanks and kind regards!