boeg

Hi So I like using the ratchet for a kinda background beat to jam to, but I was trying to make it more interesting and found out using it in combination with the glitch delay is just perfect. Only problem is that I only want the ratchets "output" to go into the glitch delay. The rest of my signal should not be "glitched", if that makes sense. I was trying to come up with a way to do it using splits, but I couldn't figure out how to get my desired result. Hope it makes sense. Sincerely, Chris

Thank you! I never thought of splitting the the FX Loop send like that. I see that it can work. However, it's really complicated, and I think I would have to replace my pedaltrain metro 24 with something a bit bigger for that kind of cabling, because right now, there is absolutely no room to take cables in/out except at the input of my tuner, and at the top and left side of the HX Stomp. Everything else is tightly fitted down with probably too much dual lock and the only way to take a cable out is to take the pedal off the board, and as I understand it, when I switch between the rigs, I would have to de/attach cables from the FX Loop side of the Stomp... Maybe I could solve this problem by getting a bigger pedaltrain and then introducing a switcher like a GigRig G3 where all the ins and outs goes from/to that. Any thoughts on this?

Hi I have a pedalboard based around an HX Stomp where I have some pedals going into the L/MONO input of the stomp, then a cable going from the FX loop SEND/stereo output into a Ventris and back to the RETURN L/MONO input, and then a cable from the OUTPUT L/MONO going to DI. And the HX Stomp then provides some effect blocks as well as amp and IR. So it's a "full rig" like this: guitar -> tuner -> other pedals ... -> HX Stomp input -> HX Stomp FX loop send -> Ventris -> HX Stomp FX loop return -> HX STOMP output -> DI However I also have a nice AC30 that I haven't been playing much since I got my HX Stomp since I cannot figure out a good way to hook it up with my current incantation of my pedalboard. I'd like to be able to use my pedalboard with HX Stomp as a "full rig" into DI as it is now, but I'd also like to be able to just "replace" the amp and IR and FX Loop blocks with my AC30, so something like this: guitar > tuner -> other pedals ... -> HX Stomp "front" -> AC30 input -> AC30 FX loop send -> HX Stomp "fx loop part" + my Ventris -> HX Stomp to AC30 loop return Obviously, I can do that by changing my cabling on my pedalboard, but I'd like to get a setup where the only cabling to hook things up is the input of my tuner as well as the inputs/outputs of the stomp where I can easily just run it as a "full rig" as in example one or with my AC30 in the mix as in example two. Is that possible, and if so how?