Michael_E

On 12/2/2020 at 4:45 PM, rd2rk said:

I'm not quite sure what you're after when you say:

 

 

If I've interpreted it correctly, attached is an example preset showing how it's done in a single path. Path A (reverb will be on the L/Mono Out, Path B (delay) will be on the RIGHT Out.

Pay attention to the panning in the split and mix blocks.

 

 

MichaelE.hlx 5.35 kB · 0 downloads

Thank you!  I have been able to figure out the panning thankfully.  This will help me to refine the path.  Much appreciated.

1 hour ago, JackRabbit160 said:

Has 3.01.0 been pulled already? I no longer see it on the Downloads page.

 

I already installed it, and it did fix an issue I was having with the HX effects, but a little curious as to why it's no longer available.

What was it that the update fixed?  I too would be interested to know why the update has been pulled.

Regarding the use of backups....  I was prompted to do a backup when I installed this update.  I did so and when the update was finished, all routing and patches and such stayed the same as I routed them.  Nothing got funky at all.  I wonder why some of you folks are having a problem?  Can be frustrating for sure.

Does anybody have any idea what this update is fixing specifically?

strangest thing happened last night. I have a clean/dirty amp rig and I was integrating the foot switch for dirty amp channel switching. 
I took care of the hum issue by clipping the ground on the FS cord. 
I then started having problems with the volume controls on the amp not engaging properly (like I could only hear preamp fizz), then the hard pans for each amp started feeding the other amp. Very strange stuff. 

OMG I feel like I am just coming up to speed in the age of the combustion engine.....

I am reading the manal..

My goal is to have a patch from a footswitch, go to to a specific amp.  I have one clean and one dirty.

I also have a Source Audio programmable EQ2.  I currently have that in line after my outputs to the amps [should I put it back to the front end, receiving my guitar signal and splitting to both inputs of the HX unit?].  The EQ2 has parallel outputs, meaning that I can send different eq values to each amp. I have this hooked up via midi to the HX unit but I don't know how to access this yet as I would like to have specific presets from the EQ, go along a patch in to a specific amp.

I have two different fuzzes in each loop.

Is there a tutorial that will walk me through these most basic of tasks?  Good grief I feel dumb.

Thanks