jleifer1349

I've been trying to dial in my clean tones, but I've found when I let a note ring out it doesn't decrease in volume linearly. It will ring out at full volume then decrease in volume abruptly and continue to ring out at a lower volume until the signal is gone. This is not the case with my Boss GT8 which the HX is supposed to be replacing. I've done a few A/B tests against the two units with effects on and off. I'm getting a nice linear decay of the signal from the GT8, but the HX stomp has this sudden decrease in volume once the signal starts to decay. I've turned off the input gate and removed all effects but still get this problem. Tired using headphones as well as the the out from the HX Stomp into a separate UBS interface into a DAW I've tried messing with some compressors to try and mitigate the issue but still gives me a noticeable sudden drop in volume when trying to hold out a note.

Hi, I have two presets: One for clean, other for distortion, Both presets have the looper and FX loop L (neunaber immerse reverberator and rubberneck delay) I'd like to loop the clean preset using the pedals in the FX loop L, then switch to the distortion preset and be able to disable the FX loop L (using the footswitch) for the distortion preset but when I switch off the FX loop L in the distortion preset, it also disables the FX over the looped clean preset. I have both looper blocks at the end of each preset, which I thought would have the looper record the clean tone with the FX loop applied, but that doesn't seem to be the case I'm a new HX Stomp user so I figure I'm doing something incorrectly