Bakerbaker19

Got it. I took note of which way the memory banks were scrolling and held the momentary switch, which stopped the scroll on the looper. Not sure why, but the 0 & 127 assignments for DIM/LIT aren’t the same from preset to preset, but I’ll look out for it as I’m building out more. Thanks for the assist!

Thanks for following up! From what I understand, the Boss looper requires two sets of info to operate commands. It has to have a 127 and then 0 in a quick burst. When I tried using the non-toggle CC, it starts the command and never stops so the memory banks just go in either direction until they hit 99 or 1. My main confusion is why my original set of Command Center settings will work as desired on one preset but then after being copied to another preset, will not work. To your point about when the preset loads, I can go back to reload the original and they’ll work as expected again.

I’ve recently looped my Boss RC-5 into the Stomp and have had success controlling memory bank increase and decrease via midi sent from the Stomp via Command Center. But, once I change presets (from one I built from scratch to one I hijacked from the factory set) the RC-5 starts rapidly scanning thru memory banks even tho I’ve copy/pasted my Command Center settings and saved them on the new preset. There are no overlapping button actions and I’ve turned off the sent PC changes in my stomp global settings. I’m using a Mosky Dual Switch on FS4 & FS5 to control the midi changes. Note: I’m also using a Jet Micro for additional stomp/snapshot control. Is there some underlying midi transmission I’m missing? Any help would be huge. Thanks in advance. **Midi Settings** Memory Bank Increase Toggle > channel 6 > cc80 > start 0 > end 127 > momentary Memory Bank Decrease Toggle > channel 6 > cc81 > start 127> end 0 > momentary