Mosat

Thanks. I’ll report back if that happens. But in the scenario I’m describing, I’m not using the amp profiles in Helix. I’m just using it as a pedal board into two amps, the second going on and off.

FYI - If on the rare chance that anyone is running this kind of thing, you can assign a footswitch to a mono send to a second amp to send/kill signal. So, I have an "Amp B" switch that sends out from send 1 to the front of an amp.

Perfect! Thanks.

Hi, I just ordered the Helix and am primarily using it to replace my pedalboard, no amp/speaker simulation, into the front of two amps, JCM 800s with no effects loops. My current rig includes and A/B/Y switch. One amp is always on and the switch is set as a Y, so when I hit hit, the signal goes to the other amp as a boost/coloration of sound. I am wondering if it is possible to set such a configuration in the outputs section of the Helix and assign a footswitch to be the Y selector. I see the unit has two 1/4-inch outs, but I have not found answer to my searches on this forum, Youtube, etc. to this question. I assume right now the setup is mono (L) and stereo when both are in use. Thanks so much.