thomhu

woops Forgot to list the product - it's the pod go wireless with firmware 1.3 -Thomas

I would like to assign the "drive" knob of the amp simulator to a switch. Kind of like on a analogue setup where you would switch to channel 2 for a little more dirt. Since I am not using the effects loop, in one of the factory presets I want to use that switch. I go to the drive knob on the amp , push the button down, tell it to learn, and then press the switch. It asks for a range and I enter a number in the low and high boxes slightly higher than my clean sound. Then I tell it to replace instead of merge. However, when press the switch, I get no sound. What am I doing wrong? Is only a pedal assignable to amp drive and not a switch? Thanks, Thomas