Ok so with the presets I am using I have it split where I have my signal run two ways, one out to the 1/4 in and running into the effects loop of an amp, effectively making the amp a cab, and the other running through a cab sim out of xlr and into an interface. When I listen through my amp the presets sound good but when I turn the amp off and try to use headphones, I get a really crappy low end that almost sounds like its overloading and the sound breaks up a bit and leaves me with a crunchy mess.
I am fully aware that I my just be bad at building presets so I have attached my main preset to this post if anyone wants to look at it and tear it apart
The main fix I have found for now is throwing a horizon drive infront of the amp block, which seems to tighten the sound and take some of the low end off, but then it sounds super bright and thin through the amp. I get that I might need to just have different presets for different situations, but if anyone has any idea on how to make this better it would be great because one of my goals for the helix was to be able to use it at gigs running out of both outputs, xlr to FOH and 1/4 to an amp for stage volume
Any help would be greatly appreciated!
For those wondering I am using a UA Volt 2 interface and Beyredynamic DT 990 pros (250 OHMS)
Marshall_W_ Cab.hlx
