Peetem_2023

So got everything working! Really appreciate the guidance. I just wish I could alter the parameters/factory settings on the effects when they are called up. Kinda a bummer - for example, the Phasor only has a 22% mix on one of the factory settings - I would like to dial it up to 50% (which yes, I can do via MIDI, so probably a bad example - a better example would be Tremolo speed). Like the I did find the settings for each factory effect also vary by the type of amp you're using. Anyone, its better than nothing!

Got it. Not sure how to send a "wait" command, but I'm sure I can figure it out. ;-)

May thanks to everyone for your help. As my MIDI controller uses an Arduino Mega and Teensy, I'll hard-code each button with the specific MIDI CC#'s and sequence. But, I didn't want to start doing that until I was sure its not a waste of time. So this has been a big help. Again, many thanks!

I purchased a Catalyst 100 and love it. I built a Midi controller and it works perfectly. Each amp bank has only one effect you can assign to it. Kind of a bummer because some songs that I play I need to be able to change between two different ones. Rather than change the bank to a new Amp (which has a very slight delay - needs to be fixed as this is one of the slight drawbacks of this amp), I would rather just change the effect type. Is there any way to change the effect by sending that bank using midi CC code/note? Thanks!