jarablue

Would I ever need to run effects in parallel? I am new to effects pedals like this and am a newbie relatively...been playing since 18 and now am 49. Not sure how that works. But ok. I am going to def have fun cause life was hard man! How do I direct the signal to each input? Use 2 cables? How do I configure that in the HX? Also will the sound come out from top boost and normal at the same time in the amp? I never knew it could do that if it does. Thought only 1 input was active at a time. Thanks!

Hi everyone. I had the pod go and realized I don't need amp or cab sims since I am plugging into an ac15 amp. Is there any setup or config in the settings of the hx I need to do before using it with my amp? I am going to update the firmware but just didn't know if I needed to edit any settings on it to get a proper setup going into my amp. My ac15 does not have an effects loop. Only normal and top boost channels. Thanks!

So if I get my amp clean, I can use the amp/preamp to simulate other amps/preamps on my ac15 amp? Just making sure I got that right? I am actually thinking of getting the HX Effect unit instead of sticking with the POD GO. I do not need the amp/cab sims at all. Do you guys think this would be a good move? Returning the pod go and getting the hx effects? I am thinking for my use case it would be the better way to go. Any ideas?

Is there any reason I should use the fx loop block on the pod go? When I turn it on, it cuts off all sound to my ac15. Would I need to use the fx loop block on the pod go for any reason? Also I will turn off the cab/ir blocks on each preset then create my own presets with them turned off. Is there any reason I should use the amp/preamp block going into my ac15? If I am not using any distortion or any effects at all from my amp other than volume (no treble, no bass. Just volume)?? How do I disable the ac15 drive/distortion to get it clean as possible to use the pod go amp/preamp? Or would it be better to just disable them both on the pod go and use my amp fully with just effects? Thanks again for the help!

So I have a Vox AC15 amp. I bought the pod go mainly for effects since I am a bedroom player and would like to use the amp/cab sims when I connect to my pc but for now while using my ac15 I just want to disable all amp/cab processing and use my ac15s sound. What is the best way to do this? Thank you for the help! :)