TonyParnham-1945

Hi, To; Just Startin, I have tried all the settings and have decided to leave it in the 'AUTO' mode as there doesn't seem to be a significant difference other than a little loss in brightness which I feel can be adjusted with the 'TREBLE' knob when saving the patch, however see below to Uber Guru; To Uber Guru, Your advice on the MASTER DEP was a revelation. I entered the AMP module and hit the right arrow in the 2nd page and noticed that No 1 was 'master' adjustment and it was showing 100%. I turned it down to around 50% and the Super O began to dramatically clean-up. I realised that this probably represented the Master Volume when looking at the real live amp which meant I had been confusing this with the Master knob on top of the POD (dimwit that I am). Thanks to all for the input....I now realise I have much to learn with the deep editing of the HD. Tony Parnham

Hi titchy and doffe, many thanks for the replies, have tested with your advice and it all came out much better. All the best Tony

Hi titchy, Thanks for that advice I'll do some testing. Tony

Hi, I have just bought a Pod HD, registered it and installed all the latest firmware. I have a couple of Strats (single coils) and have been trying to get clean sound. Why is it that if I use one of the clean type amps I have to turn the drive right down to nearly zero before it sounds clean, thus losing strength. If I lift the drive up a shade it starts to distort. This does not happen on a real amp. I also have a Zoom G3 and get no such problem. I am a solo guitar vocalist and my signal path is Pod HD >Tonematch mixer (FLAT)>Bose L1 compact. Any observations would be appreciated. Thank you Tony Parnham