sfx70

Thanks for suggestion but that wouldn't take care of persisting the effects state that I may turn on while switching drive pedals on and off.... Hmmm

Honestly the easiest way to explain is this. In stomp mode I want the ability to group ootswitches to act like the m13 channel strips. Let's say I want to have 3 different distortions- i can group those 3 associated footswitches that control my distortions so that if I press on one footswitch it will deactivate the other 2 (and the effects associated with them). Makes sense?

Thx . I'm gonna look for Snapshot edits preferences and see what happens. The thing is that not all my solos are with delay and wah. So let's say I move to a new section or a new song where delay and wah are not required then I have to turn those two off. I play in a funk/soul band and some of the part are jammy and organic on the spot. Also our set list can change right there depending on the mood of the place, crowd response, etc. So having things preset don't work very well in this project.

Hi I set up all snapshots just with clean, dirt clean, lo gain and high gain (snap 1, 2, 3, and 4). All stomps are off on all snaps. Let's say I'm on clean and turn on my delay on using one of the 4 stomp and my wah on (activated by the EXP pedal). Then I get into a solo - I hit snap 4 for solo and BAM my delay and wah are deactivated. 2 TAPS extra required again for turn those on. Then the delay and the wah are now automatically saved on my on my cleans and my solo snap. Next song I hit solo I'm stuck with delay and WAH on which I may want off. I wish the effects controlled by stomp footswitches are completely independant than the snaps. Another similar scenario - I want to set up my MIDI amp channels to be controlled by 3 snaps (clea, lo gain, lead). I want the stomps to behave like true stomps. I hope this clears up what I'm trying to achieve. Thanks guys

Thanks for the reply. That's too bad. It would have been nice to have full control over the blocks that are controlled by the stomp footswitches.... Is there any other way to achieve what I want to do here? Basically i need the 4 sounds (clean, dirty clean, lo gain high gain) that are activated by pressing its corresponding switch vs tap dancing multiple switches and have some effects in true stomp mode. I play a lof improvisation and on the fly type grooves and need to be able to have that flexibility. That's one thing I loved about my M13. Thx

Hi all Is there any way to assign the state of the block to a snapsot manually vs automatically in a 4 snapshot / 4 stomp mode? I want to have clean, dirty clean, lo gain and solo on the 4 snapshots and completely independent stomp on the other row. Scenario: the delay or chorus (that are controlled by stomp footswitches) active while I switch clean to gain to solo. Thx