A little audio test: integrating the HX Effects and external pedals using FX loop

[optofonik]

Just finished wiring everything in except the two Boomerangs, expression pedals, and Behringer FCB1010. I needed to call it a day and decided to close the day out with a little ditty.

 

 

 

 

 

For the purpose of this test, a single two bar guitar loop is prerecorded into the Wally then slowed as far down as the Wally will allow from dead center. I slowly raise the loop speed up to normal and the guitar loop plays back at regular speed until the end when it's slowed back down before the fade out. The "ambiance" is nothing more than the wet side of the guitar loop, highly effected.

 

It was recorded on a Tascam DP-008EX using it's built in mics and quite frankly I didn't go to any great lengths, none at all really , to optimize any fidelity; the low level digital clipping is quite obvious, not so low level toward the end, and the mics picked up my switching. The Tascam does much better, as do I, with a bit more effort.