bmo_javx Posted November 20, 2013 Share Posted November 20, 2013 I have owned a HD100 Mk II for a little over a year now and I am having problems with it for the second time. The first occasion the amp would run but there was no sound. I sent the head back to Line 6 and the motherboard was replaced under warranty. It was explained the stock motherboards were faulty in the early Mk IIs. This evening I have run into my second issue. I turned it on and got low volume from a clean channel. Moments later, a very loud distorted feedback began to ring through. It was at piercing volume and even after turning the volume all the way down, the amp continued to scream and buzz. I put the amp in stand-by mode to relieve my ears and turned to my computer. All of the sudden it began to scream and buzz even in stand-by mode. I am not sure what is causing this. Immediately I assumed tubes but given the problem persisting in stand-by mode, this must be something else. Any suggestions out there? I think I should have gone with a Marshal stack and Line 6 pod vice the SV. Apparently there is too much going on with a Line 6 head to function reliably. Now outside the warranty, I could use some help before dropping cash on tubes and techs to tell me Line 6 will have to fix it. Regards, Lee Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.