josephcotten Posted December 4, 2025 Share Posted December 4, 2025 When I’m using the Cosmos model, if I make any edit to the Mix knob, the model switches to something entirely different. I can’t figure out what, but possibly Euclidean. Although just now when I did it, it sounded like one of the vintage models. Has anyone else experienced this? Touching Mix causes all the settings to change when using Cosmos? I’m using the new firmware (December 2025) and through-signal is set to analog. Quote Link to comment Share on other sites More sharing options...
maxoom99 Posted December 10, 2025 Share Posted December 10, 2025 Where did you get this December firmware and what version is it? The downloads page only shows v1.10, quite a bit older. I'd like to get it too for another problem I'm having, to see if it's fixed. My problem also includes the Mix knob, but it's a different problem. See my post below yours about level. Quote Link to comment Share on other sites More sharing options...
josephcotten Posted February 5 Author Share Posted February 5 Sorry I never replied, @maxoom99; the forum notifications were off for me, and I didn’t realize it until now (Feb 2026)! When I mentioned a December 2025 firmware, I just meant that I had updated it in December, not that there was a December release of new firmware. So I’m running v.1.10 like you are. Sorry for the confusion! In any case, my issue has not been resolved. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.