Opened a Ticket for a BUG while renaming blocks and assigning them to switches.

[jpdesroc]

Wednesday I updated my Stadium XL to 1.3 with success. 
But I found what seems to be a bug in the Block/switch renaming.. 
Here is what I found: 
I use the floor switch mode named STOMPA/COMBO in COMBO mode 
to display my first 4 snapshots names on the upper switch row and my STOMP blocks A2,A3,A4,A5 on the second row. 
These all works, 
but if (in STOMPA mode) I rename any first row STOMP blocks with another name 
-> Going then in COMBO mode the Stadium shows -> the original block's names on the second row instead of my renamed ones. 
Or worst: 
If (in STOMP mode) Blocks are also renamed in the second row, 
going then to COMBO mode these blocks stay with their renamed values 
even if their active blocks have a wrong name but are the ones from the upper row in STOMPA mode. 
Hope I'm clear here.. 
For example if a first row block is a delay originaly named 'Vintage Digital' 
and I rename it 'Short Delay' because of its settings, the 'Short Delay' name shows correctly in STOMPA mode, 
but shows 'Vintage Digital' for the same block when switched to the COMBO mode. 
Looks like the Stadium only uses the factory names on the second COMBO mode row.. 
I have pictures snapshots for you showing my problem.. 

 

Waiting their replies on that..

[adflaker]

Yeah, I had a similar issue (thread here). I noticed while sending pictures to support that this only seems to happen with block toggle switches. Any switch that's set to adjust parameters is unaffected.