mallichae
-
Posts
2 -
Joined
-
Last visited
mallichae's Achievements
-
Much appreciated, Charlie_Watt! I took the POD apart last night and lifted the LCD board to see if If I could move the ribbon connector around and get it to work. It was a no go, but I did notice that there were several solder joints that could use touching up, so I'm gonna give that a shot at some point in the near future.
-
My POD X3 works fine as far as sound goes, but I have the dreaded blank screen of death. After doing some reading on this, I decided to test the Line 6 9v power supply that came with the device, and I do see that it is outputting 10.5 volts. Does anyone know from experience if the one-and-a-half extra volts would cause my issue?