badldragon

Thanks DunedinDragon for clarifying the Orange CAB question, all examples of other Helix LT user techniques using either Orange amp (with no CABS\IRs) or cab\mic emulation via XLR to FOH are most welcome

Hello Folks, Really I think I need a guitar technician Just purchased the Helix LT (late to the party)! I have a couple of scenarios to discuss: If someone can answer all the points in these questions I will happily donate a small fee to a paypal account of their choice, seriously! Helix LT using Orange Crush CR60C Amp - I would like to use the Orange amps speaker to simulate the amps\cabs in the Helix LT patches\presets, how does the following work Cabling from Helix LT to Orange Crush amp (I'm assuming it's not 4 cable method as this would use the Orange amps pre-amp) and I basically just want to use everything on the Helix LT (Amps\Cabs\Effects) through a clean speaker is this using guitar amp FX return, I'm not sure? What are the Global settings that need to be set for such a config as this e.g. send\return etc. What are the patch 'blocks' that need to be added to enable the correct signal chain Helix LT direct to PA using DI i.e. no Guitar amplifier Cabling from Helix LT to DI, would I use XLR (set to line in global settings) or use 1/4 mono out to DI and then DI to PA stage box\PA Mixer? What are the Global settings that need to be set for such a config as this e.g. send\return etc. What are the patch 'blocks' that need to be added to enable the correct signal chain? Yours Hopefully Badldragon

Hello Folks, Just purchased pre-owned M13. Firmware v2.x. When I press model select encoder to change to new effect type the selected display just flashes and I cannot change effect type. Any help\advice is appreciated Thanks BadLdragon

I have a POD X3 Pro and I wanted to add a Line6 Echo Pro unit to my stack. What is the best way to setup the wiring and configuration between the two units for optimal signal processing?