soundBerg

Power supply is 100% ok, works just fine with other identical POD unit. I have not saved my presets during reflashing dialog. FLash version 1.0 found and flashed, same thing; "Update flash" Bonus info: If I don't start the unit in weeks, its works normal for about 2-4 reboots, then stuck again = this points at a hardware design fault, that a capacitator is holding charge when it should not(?) Whats left to do except trash the bricked Pod?

+1 Add me to the list. Have tried all flash versions but 1.0 which I can't find on Line 6 website. My Pod x3 live can't boot either, it's stuck after logoscreen, it just says "update flash" w/o the three dots that are shown while flashing the firmware (which is no worries at all to perform...) This is my second Pod x3 live with firmware issues, really like to know whats going on Line 6 since these kind of faults have been around since 2008, you should be able to track down whats wrong with all this units, it's unlikley a hardware problem, so stop tell ppl to get motherboard replacements for big $$$! The product is obsolete and you only get a lollipop reputation by ignoring that you put out a product far below expected standards. I have 3 XT in the studio i work in, no problem ever and much more rugged. Can you at least publish the 1.0 firmware version which users have been able to roll back to with some success? Regards / Jonas