paulcanning

I've been using the 1 switch looper on my Pod Go and suddenly it is no longer working correctly. I can set up a loop fine and then press the assigned switch to play the loop. However, I cannot then stop the loop (should stop with 2 switch presses) or erase the loop (should erase by holding the switch down for a brief moment). It is weird, the 6 switch looper works fine. I have just updated the software but that hasn't helped. Any advice would be much appreciated.

Hi, I use a Helix floor connected to a Powercab 212 via the data cable and have presets where I use the simulated speakers within the Powercab 212. So a preset will have just the amp selected and the Powercab settings will select the speaker. With all of the new cabs within the Helix 3.5 update I assume that I would be best to revert to using the Helix cab settings and use the Powercab 212 in a different mode? Say FRFR? Any help hugely appreciated, many thanks

Many thanks Phil for clarifying that, cheers

Hi, I've just bought a Powercab Plus and connected it to my Helix LT using the L6 link cable. I've been able to program the PC+ speaker selection via the Helix (output setting) and I can see the colour change on the PC+ but the PC+ display doesn't change. I appreciate this is fairly minor but I wanted to check that is correct. Is there a change I can make that enables the display to change as well as the colour? Many thanks for any advice