seancsmith89

Hi everyone, I played two shows over the weekend, Friday & Saturday, and had the exact same issue come up and I am hoping someone can help. I started both sets with my Gibson LP >> G10 >> Helix >> Front of House. On both nights, I burst a string on the LP mid song and had to make a quick change to my backup Telecaster. On both nights, I killed the signal to the Helix with a vokume pedal at the start of the Helix' signal chain, took the G10 transmitter out the Les Paul and put it into the Fender. AAAAAAAAAAAAAaaannnnnddddd.......................nothing! Absolutely no signal whatsoever! (Obvs I had put the volume pedal back down to allow signal into the Helix. Quick change to a cable and the Tele came back to life both nights. Does anyone know of any issues with the G10 when you make quick guitar changes? A few other notes: The Gibson LP is stock; with BurstBucker pickups. The Tele (HSS pickups) has Bareknuckle Warpig in the birdge (No judgement, please :P). The helix' Z-in is set to 230k. I am not sure if this impedance setting would make any difference with the wireless kit though. Also, after this happened on the first night, I flashed the firmware on both the receiver and trasmitter, but both were already on the newest FW before the flash anyway. Final note, I didn't get a good look at the colour of the LED during the issue-I was in a mad panic as I had a solo coming up! Any thoughts?

HI all, Currently looking i investing in the Rackmounted Line 6 POD HD but there is an issue I would like to clear up before I purchase. I am currently using an old Boss GT-8 which is absolutely diabolical in terms of sounds. I set up in the 4cm so that I can place certain effects before and after the preamp (Marshall JCM 2000 DSL). When I set up the signal chain, I can place the pedals external effects loop into the chain as an active component. IE: WAH>>VOLUME PEDAL>>OVD>>(Unused inbuilt preamp simulators)>>EQ>>EXTERNAL EFFECTS LOOP>>CHORUS>>DELAY>>REVERB All of the above are interchangeable so I can have any signal chain I wish. My worry is, that, from the online videos I have looked at, and a quick glance of the manual, I cannot figure out where the external effects loop in in the POD's signal chain. Am I missing something here?