sic_null

Thanks! I may just pick up a mixer then.

Newer one. Black face

Yep. Also de-authed / re-auth both units as well as a full uninstall/reinstall.

I currently have an X3 Pro and UX2 connected via USB, both activated and all drivers installed. When one of the two are off, Podfarm boots up with without the "No License" notification.When both are on however, i get the error. When i boot PODFarm as a VST, this does not happen. It registers as PodFarm platinum Only when running Podfarm as an exe do i get the error. . Am i experiencing a limitation with the software or is there a fix for this?

Wasn't sure which section to post in. Basically, i just picked up an X3 pro dirt cheap and I want to run it to my UX2. I understand I can use the X3 as an interface alone but due to my setup, it's not as convenient. My UX2 is right in front of me where as the X3 will be in a different location. Basically the UX2 will be a $200 volume control at this point i guess. I have my studio monitors connected to the analog outs on the UX2. Will either of these setups work. X3 Studio Outs (XLR TO TRS Cables) running to UX2 Line Inputs (Assuming the UX2 inputs are mono) X3 SPDIF to UX2 Stereo Monitor In (not sure if this will work) I'm trying to avoid using the headphone out on the X3 to the instrument in on the X2, would like to keep all connections on the rear of both units. Photos of both for reference