hereticaltruth

the developer's preview has been released. I do report bugs. Just looking for anyone else who has experienced this and if a solution is available. Thanks.

I'm having an issue where Logic X won't work if Helix is the output device. And by not work, I mean no sound is transmitted and the meters don't even light up in Logic so it acts like no signal is being read. Trying to change to built in output while Helix was connected caused Logic to hang/freeze. I had to disconnect the Helix, relaunch Logic and change the output to the built in output and then Logic works just fine. Is anyone else experiencing this? Any work arounds? Fwiw, I'm running a 2013 27" iMac , Helix fw 2.54, and 10.14 dp1.

Thanks for that info!

I might have part of this sorted out. Am I correct in this: Bypass assign is how you assign the foot switch to turn the effects on and off? Vs Controller assign which determines which foot switch controls the parameters? Is there a way in the Editor to make a parameter apply only to the selected snapshot as opposed to the preset? I can't seem to figure out how to do that. Any changes in the editor seem to be global changes unless I push/turn that parameter on the floor board first.

I recently got the Helix board and this morning updated to the new 2.20 firmware and trying to delve into snapshots. Given how easy the rest of this unit is to figure out, I must say, this has been a day filled with frustrations. I took me a while to figure out some things just can't be done from the Editor. But I eventually figured out how to control some settings globally and how to single them out for individual snapshots. I'm trying to set it up so the bottom switches to change snapshots and the top switches are stomp boxes for the effects in the snapshot. But now, after setting up a couple of snapshots, I can't get the stomp boxes to active the effects. I've assigned them on the board. Double checked that each effect is assigned in the editor. But stepping on the switch does not activate the effect. (Stepping on the lower switches does change the snapshot though). What am I doing wrong?? Other than this, I've been enjoying the heck out of this thing.