My expression pedal has stopped working for me, any ideas on how to trouble shoot this. Is this hardware?
I have been trying to use this pedal and it no longer has any effect on my patches.
Have been able to switch controller to variax volume or tone control and those work fine but expression pedal (exp1 or exp 2) seems to be dead.
Try to reinstall flash memory but this had no effect.
Found this and it solved my problem.
f the Onboard expression pedal of the POD HD500 does not sweep through parameter values as it normally would, you may need to perform a pedal calibration to reset the functionality of the expression pedal: Hold the down the RIGHT ARROW button on the 4 Way Nav Pad while powering the unit on, until you see the â€œTest Modeâ€ screen (Pedal Cal, etc.), and then proceed with the steps below:
If not already selected, use on the 4 Way Nav Pad to select â€œPedal Cal,â€ as shown above.
Press the VIEW button.
Set the pedal to the minimum â€œheelâ€ position, then press the A footswitch to set a value for the Duty Cycle. Youâ€™ll see the value set to â€œ100.â€
Set the pedal to the maximum â€œtoeâ€ position, then press the B footswitch to set a value for the Duty Cycle. Again, youâ€™ll see the value set to â€œ100,â€ as in step 3.
Press the C footswitch to prepare for automatic selection of the Scaled Pedal Value and move the pedal from min. to max. You should see the Scaled Pedal Values read â€œ0â€ at the heel position and â€œ255â€ and the toe position. If you get values other than 0 and 255, power off and repeat these steps, starting at step 1.
Press the D footswitch to save the settings. Youâ€™ll be returned to the Test Mode screen and the Pedal Cal item will show a â€œPâ€ to indicated that the pedal calibration is complete! Power your device off and back on again to start using it.
***Please Note: Re-calibration of the POD HD500's expression pedal is necessary after performing a Global Settings reset. Instructions for how to perform a Global Settings reset is available here.