Hey folks - I've got my floor unit set up to have 4 snapshots across the bottom, 4 stomps across the top for each preset. The goal is for each preset to represent a specific amp/guitar tone with the snapshots set for common or specific song parts (verse, chorus, lead, etc). I'm hoping to use the 4 stomps for in-the-moment adjustments, adding or bypassing an effect, etc.
It's close, BUT. I find that when I select a stomp, the selection applies only while I stay in the same snapshot. When I switch to the next section of the tune, the effect won't be there unless I kick it again. I was hoping/assuming the stomps would stay active across snapshots. Like saying "If I stomp this, just leave it on in all my snapshots until I un-stomp it." But I can't find a setting to make it so. Am I asking too much? Doing it wrong? I find this is the most confusing part of working with Helix.
Here's what a sample preset looks like for me right now:
Preset: 12A Telecaster Twin
FS2-5 = stomps (e.g. slapback, chorus, etc)
FS7-10 = snapshots (e.g. clean, overdrive, lead built with a combination of amp, IR, distortion, compression, EQ and reverb)
Thanks for any insights you've got!
