I received my new unit. This one sounds much better, very little if any of the blown speaker sound I had with the other one. It came loaded with 1.11 so the first thing I tried after checking the sound of the presets was to attempt to download the new firmware 1.12.0. If you read the instructions when it starts it states to make sure your version of POD GO Edit is version 1.1.1. I had 1.1.0 installed so updated it first. The instructions did not mention uninstalling 1.1.0 before updating so I did not uninstall. The new version installed fine. the existing shortcut on my desktop was still there, and launched the new version. The new version launched fine and connected fine. I started the update and it complained about it the GO not being a True S34 or something like that, not sure and I didn't take a picture or write it down. The pedal still said downloading so I was afraid to stop. I let it run about 10 minutes and nothing changed. Shut off the pedal, closed Edit and disconnected the USB cable. At the time I had the pedal connected to a USB hub. This time I turned on the pedal first and let boot (Thank God it booted!). Then I connected the USB cable directly into my Laptop no hub. Launched Edit and attempted the upgrade again. This time it worked perfectly. I would definitely avoid any type of USB hub when doing anything mission critical with this product.
Hope this is of some help! Good luck everyone. I really like the sounds and possibilities with this product and hope it stabilizes!