tinwhistle

I tried your solution and it worked. Thank you! I went a little further than the lazy method and unscrewed the footswitch PCB so I could see the micro switches. The one in question had what appeared to be a light amount of carbon around the switch. I cleaned it and applied some Deoxit with the small brush applicator, then blew it out with a computer keyboard cleaner. I did a couple other switches as well. After reassembly and a little time for drying I plugged it in and the glitchy problem is gone. I appreciate your advice on this. All it took was time and Deoxit.

I have a Helix LT out of warranty for some time. One of the footswitches is working intermittently. I am handy with PCB board soldering, so I though I would replace the microswitch, however the plastic actuator plunger needs replaced. I tried looking everywhere. FullCompass is backordered on parts. Is there a source for the little actuator piece?

I’ve put the Radar in my fox loop, turned off the cab in the patch, and used the Radar for the cab. Sounds nice, but it adds a low hiss through the PA. It would be great if anyone that has used this setup would post their tips and favorite patch/sim combinations.