ringo05

Yeah I have been having the same problem, although mine freezes up while inside a patch trying to edit it. I have had to do a reset (footswich 9 & 10) a number of times now because of this problem. Very frustrating.

Sorry for the late reply, been on holidays. Thanks tmntshredder, that is exactly what I was after, works a treat!

Anyone! I still cant switch channels on my JVM while in stomp mode. Can anyone help?

Can anyone help me with this?? For the life of me, I can not figure out how to send a midi message from the Helix to my Marshall JVM410h within a preset. (in pedal/stomp mode) I have been successful in sending messages from Helix to JVM when changing presets but not when I'm in pedal mode. I tried going into the command centre and assigning a foot switch to send midi but nothing.... :huh: it's got me stumped!!

I have been into command centre and tried to assign a foot switch with midi so that I can switch channels on the amp but nothing is happening. Only when I'm in preset mode will it accept a midi command by changing presets.

No worries drjs83. I got some time off these next few days so I will be diving deeper into it and start creating some custom patches.

Hi drjs83, I am just going through the process now, of setting up my Helix with JVM410h. I only got my Helix a few days ago so I am still working it all out but so far so good. I have connected it via the 4CM method and connected a midi cable for switching channels, fx loop and reverb on the JVM. I can now switch between using a channel on the amp (with or without fx) or choose to use the power amp of the jvm and slot in a preamp from the helix. I was using a TC Nova system before this and could never make it work seamlessly with the jvm either. The helix sounds freaking amazing and plays very well with the JVM.

I'm in South Australia. Purchased it from Derringers Music Adelaide. It was the last one in stock.

I cant seem to send midi commands when I'm in pedal mode. I can send a midi command when I'm in preset mode so that when I change presets it will change channels, reverb, master vol, FX loop, on my amp but I want to be able to switch between my amp and helix preamp within pedal mode. How do I send midi commands to the amp when in pedal mode?

Ok so I got my Helix yesterday! Woop woop!! :D Now..... I have been busy all day, setting up patches, from scratch. I have set my Helix up using the 4CM method and MIDI cable as well to change channels on my JVM. The one problem I am having is..... I cant seem to send midi commands when I'm in pedal mode. I can send a midi command when I'm in preset mode so that when I change presets it will change channels, reverb, master vol, FX loop, on my amp but I want to be able to switch between my amp and helix preamp within pedal mode. How do I send midi commands to the amp when in pedal mode? :wacko:

Yeah awesome!! I'll give it a go. Thanks!

Thanks sonikimage, do you notice much of a gap when switching channels that way?

Yeah I have used midi on my old TC Nova system to change channels before but when using a midi cable there was a significant delay in the channel switching, like up to 1-1.5sec. What I am wondering is if I can plug into the 1/4" footswitch jack on the helix and assign switches on the helix to change channels on the amp, just as I do on my stock JVM footswitch?

Hi Guys, So I have finally purchased myself a new Helix. I ordered it yesterday so it wont be here for another couple of days and the anticipation is killing me. Anyway..... what I am wondering is if anyone has tried or knows if switching channels on the Marshall JVM410H is possible using the Helix? I have looked everywhere but cant seem to find any information about it.