Search the Community
Showing results for tags 'dt25 reverb not working'.
Found 1 result
-
here is the problem I am having. I like to have a little reverb from the DT25 in my patches when using the dream rig. Lately, when switching to a patch, the reverb on channel A does not always work when I adjust the amp knob. I have had an issue where I go to turn the reverb all the way off on the amp, but the reverb still persists.IF I hold the knob for a scond or two full off, twisting it till it will not move any more and hold, it will go off. If I select a patch and turn the reverb up on the DT25, the reverb will never go off. I have to hold the reveb knob all the way off by rotating and holding the reveb knob fully off for a 1 second count. I went through all this with support and they said it sounds like I may have a bad reverb knob and need to have it serviced. It is a little over a year old and out of warranty. I am tired of having line6 equipment go south on me and just outside of warranty. I spent too much money on this dream rig to have it serviced shortly after the warranty goes out. It is almost as if there is a planned obsolescence and you should always buy the extended warranty for any line6 product. I am wondering if it may be the month or twio older firmware change that has to do with this or not. When I switch the patches, the amp responds as expected. It is only when I twist the reverb knob on channel A that the DT25 goes south. Channel B does not exhibit this behavior.