Search the Community
Showing results for tags 'outputpaths'.
Found 2 results
-
Hi, I just ordered the Helix and am primarily using it to replace my pedalboard, no amp/speaker simulation, into the front of two amps, JCM 800s with no effects loops. My current rig includes and A/B/Y switch. One amp is always on and the switch is set as a Y, so when I hit hit, the signal goes to the other amp as a boost/coloration of sound. I am wondering if it is possible to set such a configuration in the outputs section of the Helix and assign a footswitch to be the Y selector. I see the unit has two 1/4-inch outs, but I have not found answer to my searches on this forum, Youtube, etc. to this question. I assume right now the setup is mono (L) and stereo when both are in use. Thanks so much.
-
Just upgraded my Helix LT to firmware 2.92. Now when I edit a patch and select the OUTPUT block at the end of the top signal path, with the intention of sending it to the bottom signal path, it only gives me the choice of Path 2A. Options Path 2B and Path 2A+2B are now greyed out. Under 2.90, I could select Path 2A+2B to ensure I took the stereo signal from the top signal path and input it into the signal path at the bottom. Now I can only output the signal path at the top into the bottom signal Path 2A. The other options are now no longer available - why? Is this an intended update or is it a bug? Thanks.
