Please ensure Javascript is enabled for purposes of website accessibility Jump to content

Search the Community

Showing results for tags 're-amp'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Community Support
    • Multi-Effects Units
    • Variax Instruments
    • Amplifiers
    • Computer Based Recording
    • Live Sound
    • Pedals/Controllers
    • Dream Rig - Line 6 Product Integration
  • General Discussion
    • Share your Settings
    • Line 6 Lounge


  • General FAQ
    • Operating System-specific Information
  • Tutorial Videos
  • Effects/Controllers
    • HELIX/HX
    • DL4 MkII Stompbox Modeler
    • FBV Controllers (MKII / 3)
    • M5
  • Amplifiers
    • Powercab
    • Catalyst
    • Spider V
  • POD
    • POD Go
    • POD HD X
    • Pocket POD
  • Guitars
    • JTV / Shuriken / Variax Standard / Workbench HD
  • Relay/XD-V Digital Wireless
  • Recording
    • Helix Native
    • Metallurgy
    • Echo Farm/Amp Farm
    • POD Farm 1/2.0/2.5
    • Computer Audio Set Up and Troubleshooting
  • Legacy Products
    • POD
    • Amps
    • 1st Gen Variax Guitars / Bass / Workbench
    • Effects and Controllers
    • AMPLIFi Series
    • Live Sound
    • Digital Wireless
    • Mobile Products
    • POD Studio / Tone Port / GuitarPort
    • Software
    • Dream Rig

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Registered Products

Found 2 results

  1. So I'm working on a little project where I need to record the same signal through an effect with several different settings in hopes I can get it tone-matched. My DAW of choice is Sonar (Cakewalk) which I have been using since it was a DOS program !!! So I kinda know my way around it. I'm currently using a Focusrite Scarlett 8i6 interface. After about 30-45 minutes of epic fail and a few occasional loud squeals from attempting to use the loop-back ability of my DAW, I remembered the Helix manual mentioned re-amping... and the helix has the ability to add loops. About 15 minutes was all it took and most of that was copying the source file to the laptop I use with the Helix in the other room and plugging things in. The DAW (Sonar) was up and running and setup to record within the 1st 5 minutes. I just followed the instructions on page 53 of the manual. I created a pre-set, and the only blocks were a send and return (set to 100% mix). Done !!! What an amazing unit.
  2. Hi, I tried to re-amp using a real amp and my tone port UX8 with no success. All outputs from 3 to 8 (1 and 2 is for my monitors) produces extreme hum or "SHHHHHHHHHHHH" sound when plugging it into my Real guitar amp. I do not even have to send a signal through the output to produce this noise. As soon as the jack is connected the extreme "SHHHHH" starts. I have tried isolating the problem and found it must be the TonePort itself. I done the following tests: 1) To eliminate the cable I plugged my guitar into the cable that goes to the amp - NO NOISE. I immediately unplugged my guitar and plugged it into the TonePort - NOISE 2) I have switched off everything else e.g. Computer, Monitors. Only my tone TonePort was on. SAME NOISE. Does anyone have ANY other suggestions? I am at the point of getting rid of the TonePort. Another user experienced the exact same problem in this thread:
  • Create New...