Jump to content

Search the Community

Showing results for tags 'sub'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Community Support
    • Multi-Effects Units
    • Variax Instruments
    • Amplifiers
    • Computer Based Recording
    • Live Sound
    • Pedals/Controllers
    • Dream Rig - Line 6 Product Integration
  • General Discussion
    • Share your Settings
    • Line 6 Lounge

Categories

  • General FAQ
  • Tutorial Videos
  • Effects/Controllers
    • HELIX/HX
    • Firehawk
    • FBV Controllers (MKI / MKII/ 3)
    • M5 / M9 / M13
    • JM4 Looper
    • Stompbox Modelers / ToneCore
    • ToneCore Development Kit
  • Recording
    • Helix Native
    • Echo Farm/Amp Farm
    • POD Farm / POD Studio / TonePort
    • Computer Audio Set Up and Troubleshooting
    • Riffworks Line 6 / Standard Edition
  • POD
    • POD HD Family
    • POD HD500/HD500X
    • POD HD300/400
    • POD X3 Family
    • POD 2.0 / PODxt Family / Pocket POD / FloorPODs
  • AMPLIFi Series Products
    • AMPLIFi 30/75/150/TT
    • AMPLIFi FX100
    • Videos
    • Tone Creation
  • Amplifiers
    • Spider V
    • Powercab
    • Firehawk 1500
    • DT50/DT25
    • Spider IV/Spider Online
    • Spider Valve
    • Spider Jam
    • Vetta
  • Live Sound
    • Relay/XD-V Digital Wireless
    • StageScape M20d Mixer
    • StageSource Speaker
  • Guitars
    • JTV / Shuriken / Variax Standard / Workbench HD
    • 1st Gen Variax Guitars / Bass / Workbench
  • Mobile Products
    • Sonic Port devices / Mobile In
    • Mobile Keys
    • MIDI Mobilizer
    • Mobile POD app
  • Dream Rig
  • Legacy Products
    • Amps
    • POD
    • Effects and Controllers
    • GearBox
    • Line 6 X2 Digital Wireless

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


Registered Products

Found 1 result

  1. Ok really annoyed .. I've invested thousands in line 6 Live sound, so the mixer and L3T tops etc. all have been great and the 6 support has been excellent but .. Needed a Sub to go with it so bought a L3S second hand as brand new they are very very expensive. . and im so glad I didn't get this brand new the sub is REALLY under powered, the drivers are a pair of 250 watt and no where near the 1200 watt advertised.!!!!!! the sound is muddy and weak see below .. The issue I experienced was when I turn up passed 12 o'clock I'm getting all kinds of ugly distortion and everything just shakes rumbles .. because I don't have another to compare too I assumed this is how they sound , but had a VERY experienced speaker engineer/ technician take a look at it out and he sent me the following report , I need to know if anyone has had the same issue or if this is normal operation ???????????? " This Line 6 L3s was presented to us for repair/inspection along with the complaint of poor output levels and poor Bass performance. Upon inspection, the lower bass driver in enclosure exhibited signs of mild breakup. No physical damage was visible, however, an AC impedance measurement yielded a possible shorted turn at an impedance of 2.13ohms @1khz. A driver replacement was recommended, but we feel this would not significantly improve matters in terms of increased bass levels. The amplifier modules were then tested at 200hz applied to the rear input panel and the loudspeaker outputs were terminated into a precision 4-ohm dummy load. Both modules produced an output of 21 volts RMS each which equates to 110.25 watts RMS per module into each 4-ohm driver @200hz. At this time the internal limiter came into operation and no further increase in output was possible. Due to the fact, there are no alignment procedures in the service manual, We were unable to confirm if this very conservative amount of limiting is implimentd to protect the drivers and amplifier modules, and is indeed correct or if an issue exists. However, It is also interesting to note in the published specifications Line 6 only lists a "peak" output power of 622w per amplifier and not a continuous RMS output. We are of the opinion this figure is somewhat meaningless In a real world environment and precludes us from quantifying any measurements. Given that the Hypex amplifier modules used in this product are only rated at 250w RMS And the drivers are rated at 350w RMS coupled with the limited amount of specifications and calibration data available to us, We are of the opinion this unit is functioning within the manufacturer's designed criteria. " over to you guys have I just wasted £800 or can something be done ???
×