MGblade Posted July 29, 2013 Share Posted July 29, 2013 i,ve created a great patch for my hd500-dt25, it,s a dual amp patch , channel A: plexi 100 brt , channel B: j-45 brt. my problem is that channel B only works if i activate the effect right in front of the two amps, when turned of channel B stops working too so i only hear the plexi 100. my chain is: noise gate - tube drive - screamer - boost comp - analog chorus - the two amps - mixer set 100%L/100%R - delay - studio eq any help apreciated Quote Link to comment Share on other sites More sharing options...
evilmikehoo Posted July 29, 2013 Share Posted July 29, 2013 Check your footswitch assignments. The two may be assigned to the same FS. I've done this a few times already!! lol!! Let me know if this is the case. The "two" meaning the effect and the ch b amp. Quote Link to comment Share on other sites More sharing options...
MGblade Posted July 30, 2013 Author Share Posted July 30, 2013 unfortunately that's not the case, the two amps don't have FS assignment, I,ve tested it again with a new patch without effects just two amps (other) and again just channel A comes through, until I put an effect (any) right in front of the amps and turn the effect on. Quote Link to comment Share on other sites More sharing options...
MartinDorr Posted July 30, 2013 Share Posted July 30, 2013 Check your input assignment. If you have nothing in front of your 2 amps you need to select Same for input 2 so that your guitar signal gets routed to both amps. If you put a mono effect in front it will send its output to both paths and you should hear what you experience. If you put a stereo effect there you should have teh same problem. Hope this is it, Martin Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.