Saving Tones Without Using Device???

[JoeNasian95]

Hi all! I've had my Firehawk for about a year now, and I'm satisfied with the tons and synchronicity it has provided so far. I do have one qualm though:

 

Say I'm practicing for a gig and my phone has run out of battery. How would I edit and save a patch purely on-board my Firehawk?

 

This might be a simple answer that I just haven't figured out yet. Thank you!

[silverhead]

The latest Firehawk manual describes the procedures for editing directly on the device. See above tabs. Support - Technical Support - Manuals.

[teddysasse]

hold down whichever a/b/c/d until it flashes, let go then hold again

[VAX700]

You can modify and save preset parameters, without using the remote app, by entering Live Edit Mode directly on your Firehawk FX. The answer is simple, but the process is a bit too long to explain here, so check out the manual (Rev. E) as indicated in silverhead's post above. And for a quick overview, see the L6 tutorial on Live Edit:

https://m.youtube.com/watch?feature=youtu.be&v=p2qlEX4Fwks

 

Also, you can quick save any tone adjustments you make with the Drive/Bass/Mid/Treble/FX/Reverb and Blend modes (on the Master Volume Knob) by pressing and holding the currently lit preset toe switch (A/B/C/D) until the display flashes with an arrow next to the bank/preset number (eg. >06B); pressing and holding the same switch again while the display is flashing will save your adjustments. If you don't save, the display stops flashing in 5 sec., your changes remain set but they're not permanently stored.