HX stomp and Mastermind PBC

[P-air]

Hi,

 

I have a switch on the Mastermind PBC assign to the output of the Mixer output of my HX stomp.

The switch is setup to boost the the output of the Mixer to a +3.5 db.

So if i press the switch on the Mastermind PB the output volume of the HX's mixer is raised by 3.5 DBs.

I have setup the mixer of every preset on my HX to respond to the CC of the Mastermind controller's switch.

But if i send a Program change from the Mastermind to the HX, the HX changed preset but the Mixer does not respond to the status of the Mastermind switch.

The output of the Mixer is always at 0 DB even if the preset on the Mastermind has the boost switch engaged meaning a 3.5 DB boost on the output of the HX's Mixer.

Any cues?

[rd2rk]

I don't have a Mastermind, I have an FCB1010 with UNO.

MIDI is MIDI. If your Mastermind can send a PC followed by a CC with ON/OFF Value (127/000), we're on the same page.

 

I set up two presets on the FCB, one sends OFF (CC Value 000) with the PC, the other sends ON (CC Value 127). I also have a switch set up to Toggle ON/OFF. All the CCs are set to the same CC#.

I set up two presets on the Helix with the Output Block set to 0.0 min/4.5 max (any max is  good), toggled using the CC# I'm sending from the FCB.

 

When I call the preset with the Output set to 0.0, that's what loads. When I then call the preset with the Output set to 4.5, that's what loads.

This works every time. If I toggle manually, then change presets, it works as expected.

 

IOW, the idea is sound. I can do it with the FCB, no problem.

 

Try using a MIDI Monitor to verify that the Mastermind is sending what you think it's sending - a PC followed by the required CC with the correct ON/OFF Values (127/000).

Make sure your presets on the Helix are set with the proper min/max on the Output Blocks, and that they're both set to be toggled by the CC# that the Mastermind is sending.

 

If you still can't get it to work, attach one of the Helix presets and I'll have a look at it.