pacard Posted November 3, 2019 Share Posted November 3, 2019 Can't figure it out. Hoping for a little help. I use the left channel to go to the left channel on my amp. I use these with my elec guitar/distorted tones. The HD's right channel goes to my amp's right channel. I use these channels for acoustic guitar/patches. I never want the hd to output to both channels. With that in mind. I want to use two amps in a single patch. Each one used exclusively. Ie, when one is on, the other is off. First problem. How the heck do I add a second amp to the patch in HD Edit? Second, any tips on how to do this and still stick within the parameters above? I've attached a pic of one of my elec patches. Thanks for the help! Quote Link to comment Share on other sites More sharing options...
pacard Posted November 4, 2019 Author Share Posted November 4, 2019 dang! was hoping someone would have a quick/easy solution. Quote Link to comment Share on other sites More sharing options...
hurghanico Posted November 5, 2019 Share Posted November 5, 2019 On 11/3/2019 at 7:47 PM, pacard said: How the heck do I add a second amp to the patch in HD Edit? from the freely downloadable Edit pilot guide: ..or directly on the device (copied from the freely downloadable Quick start guide): _______________________________________________________________________________________________________________________________________________________________________ All about POD HD500/X help and useful tips Quote Link to comment Share on other sites More sharing options...
pacard Posted November 8, 2019 Author Share Posted November 8, 2019 hmm. must have been dragging it incorrectly. thanks for the response. it's MUCH APPRECIATED. Quote Link to comment Share on other sites More sharing options...
pacard Posted November 9, 2019 Author Share Posted November 9, 2019 odd. well, alright, i'm not crazy. the only way i can drag my amp into channel a is if i drag it to the post position, then drag it to the end of channel A, then move everything else in channel A after the amp. it won't let me drag the amp to the beginning of channel A. well, at least i've made a little progress. hmmm also oddly, i don't have trouble dragging amps when starting from a New Tone patch. dang it! Quote Link to comment Share on other sites More sharing options...
hurghanico Posted November 10, 2019 Share Posted November 10, 2019 5 hours ago, pacard said: odd. well, alright, i'm not crazy. the only way i can drag my amp into channel a is if i drag it to the post position, then drag it to the end of channel A, then move everything else in channel A after the amp. it won't let me drag the amp to the beginning of channel A. well, at least i've made a little progress. hmmm also oddly, i don't have trouble dragging amps when starting from a New Tone patch. dang it! Nothing strange, just normal behavior.. If there are already blocks in path A you can drag the amp slot from pre-split position to path A but only after the last block in that path, and then if you want you can move the blocks after the amp slot. Therefore if you start editing a new empty patch (ie with still empty path A) you can drag the amp slot in path A and then add other blocks directly after it. _______________________________________________________________________________________________________________________________________________________________________ All about POD HD500/X help and useful tips Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.