kryhan Posted April 27, 2022 Share Posted April 27, 2022 Hi, I have weird problem with my POD. When i press switch "FX1" it activate "FX2" too, it's makes lopper unusable :( but when i press FX1 once again, FX2 is still active, when push FX2 again, it disactive but enabling FX1. I've changed all switches to new one, problem still presist. When i boot up POD, led above "FX1" is slightly flashing red, like TAP one but much less. Sometimes when i plugged power supply, FX1 is not lighting red, it works well. Any ideas? I've done factory reset, reflash firmware etc already :( Quote Link to comment Share on other sites More sharing options...
silverhead Posted April 27, 2022 Share Posted April 27, 2022 This is likely a hardware problem. I would open a support ticket. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.